Tuesday 22 November 2011

Newcastle's Whitecoats

The Marquis of Newcastle's Regiment of foot, known variously as the Whitecoats or Lambs, are probably best known for their defiant last stand at the Battle of Marston Moor. I'm only about 25 miles from the battle site, and when I drive past the image of the last stand often goes through my mind.

With this in mind, please meet my latest ECW foot, my take on Newcastle's Whitecoats.

Here they are, standing in a row, or two rows actually. Warlord figures, just for a change, but I modelled most of the shot with bonnets. Warlord only include one bonnet per sprue of foot, so the rest were added by me from greenstuff. This gives some variation, of course, but these bonnets would not have been a standard issue item.  One other thing I did with these figures was to paint the whole lot at once, except for the command. To be honest this was too much - I got heartily sick of shading twenty jackets, pairs of trousers or faces at a a time. Normally I do no more than a dozen figures at a time, and I think I'll go back to that from now on.



The command. The ensign is based on the designs in Osprey's Campaign series volume on Marston Moor. The sergeant, complete with partizan, is a spare pikeman body with arms added from the many extra pairs to be found in Warlord's Firelock Storming Party.


And the command again, from the side this time. The camera flash has been unforgiving as far as showing apparent shine on the ensign, unfortunately.



Shot, showing the bonnets. The fellow is the sash is getting to act as a file closer. I did a few shot with other headgear for variety.


Pikemen. The figure at the back is wearing a helm that I added using plastic card and greenstuff. I'd modelled helmets before on assorted Dark Age figures, but this was more difficult, largely as a result of the brim. I wanted nearly all of the pike to have helms, though and this was the simplest (OK cheapest, if I'm honest) way. There are various sources showing a wide selection of widely different helmets being used, from ultra-crude to relatively refined. Those I have modelled may err toward the former...


The regiment, drawn up three ranks deep this time. One disadavantage of the approach I've used for this and my Greencoat regiment (i.e. use two Warlord Infantry sprues per regiment  and cobble up the command from a single command sprue and whatever is left) is that the pike to shot ratio is way off what it ought to be. In this case, I have 16 shot and 12 pike (command is figured  as included with the pikes), for a ratio of 4:3. This ought to be more like 3:2 or even 2:1 in favour of shot, so I need to think about adding between two and eight additional shot to the regiment. I like the way Redoubt look with Warlord figures, so I'll probably go down that route.


Enjoy!

3 comments:

  1. Great looking unit and always good to see nicely converted/modified figures.

    Regards,
    Matt

    ReplyDelete
  2. Great looking unit. The Whitecoats were always my favourite unit

    ReplyDelete